Rubber Roofs for Darke County Homes, Shops and Storefronts
Most barns and pole buildings around Greenville wear metal, and that's the right call for a steep roof. Rubber roofing in Greenville is for the other roofs: the flat addition on an older house in town, the office tacked onto a farm shop, the storefront with a roof you can barely see from the street.
Rich Roofing & Services installs EPDM on those low-slope roofs and replaces flat roofs that have given up. We're a family roofing company that has worked in Ohio since 1965, based about 30 miles east of you in Troy.
If your flat roof only needs a leak chased down, our Greenville flat roof repair service is the place to start.
How EPDM Works on a Nearly Flat Roof
EPDM is a synthetic rubber membrane. It's sold in wide sheets, glued or fastened over the roof deck, and joined at the overlaps with seam tape. On a small roof, there may be only one seam or none at all.
It suits a roof with very little pitch, where shingles would let water creep back under. Rubber doesn't care if water sits for a day after a storm.
Out in open country, wind and freeze-thaw cycles do more damage than heat. EPDM stays flexible in the cold, so it moves with the building instead of cracking.
Black EPDM is the usual choice and the most affordable. White EPDM reflects sunlight and keeps the surface cooler, which some owners prefer over a heated room.
Rubber Roofing Jobs We Take On Around Greenville
Here is where EPDM roofing usually ends up in this part of Darke County.
Rubber is one piece of a bigger picture. For a heat-welded membrane on a larger commercial building, see our page on TPO and PVC single ply roofing in Greenville.
Town homes with flat additions
Older houses near Greenville Creek and the Garst Museum often have a back porch or kitchen addition with a shallow roof. That roof usually meets a wall, and the wall flashing is the detail that matters most.
Shop offices and lean-tos
A farm shop may be metal on top, with a low-slope office or lean-to on one side. EPDM covers that section cleanly and ties into the metal at the joint.
Storefronts and small offices
One-story commercial buildings along US-127 and SR-49 often have low-slope roofs. Our commercial roofing team in Greenville looks at size, drainage and rooftop units before suggesting EPDM or another membrane.
Glued down or held with ballast
On homes and small buildings we fully adhere the sheet with bonding adhesive. Ballasted systems, held down with stone, need a structure built for the weight and are mostly found on large commercial roofs.
Seams, edges and flashing
Every overlap gets primer and seam tape. Walls get a termination bar and counterflashing, vents get rubber pipe boots, and the perimeter gets new edge metal.
Why Greenville Calls a Roofer from Troy
Sixty years of roofing in Ohio, a Reader's Choice award 16 times and a crew that is background-checked before every job. We're a licensed roofing contractor, we're Latino-owned and Veteran-owned, and estimates are free with pricing laid out upfront. Read more about our family company, or see what customers wrote on our reviews page.
We also don't drive 30 miles to cut corners. Rubber roofing in Greenville gets the same seam work and flashing as a job down the street from our office, and we'd rather tell you a repair will do than sell you a roof you don't need.
From Old Roof to New EPDM, Step by Step
A rubber roof replacement out here follows the same plan as anywhere, with one extra: we schedule the longer drive so we're on your roof for full working days.
Looking at the Roof with You
We climb up, check the deck from below if we can, and note every wall, vent and drain the new roof has to meet.
Pricing It in Writing
The estimate is free. Size, the number of old layers, decking repairs and flashing details are what move the price.
Taking the Old Roof Down to the Deck
Old tar, rolled roofing or worn rubber comes off. Rotted boards get replaced so the new membrane lies flat and sound.
Laying and Bonding the Rubber
A cover board goes down, then the EPDM membrane is glued and rolled to push out air. Seams are taped and pressed.
Flashing, Edge Metal and Cleanup
Walls, vents and edges are finished, the site is cleaned and we walk the roof with you. If the steep main roof is next on your list, compare metal and asphalt options for Greenville homes, or read about a full roof replacement in Greenville.
Rubber Roofing in Greenville, Versailles, Arcanum and Around Darke County
We work in Greenville and in Arcanum, Versailles, Ansonia, Union City, New Madison and Gettysburg. If you searched rubber roofing near me anywhere in the county, or looked for EPDM roofers near me from a farm off US-36, we can get to you.
Building something new, like a shop office or garage? That's new roof installation in Greenville. For a flat roof replacement or new rubber on an existing building, send us a message or call Monday through Friday, 8 to 5.
Can EPDM go on a barn or pole building in Darke County?
Only on the low-slope parts. Steep barn roofs are better in metal. Rubber fits lean-tos, shop offices and any section with almost no pitch.
How far do you travel for rubber roofing in Greenville?
We cover Greenville and the rest of Darke County from our Troy office, about 30 miles away. Arcanum, Versailles, Ansonia and Union City are all within our regular area.
Should I choose black or white rubber?
Black is standard and handles winter well. White reflects more sun and keeps a room below cooler in summer. We price both so you can decide.
Is a rubber roof replacement noisy or messy?
There is some noise during tear-off, and we work during the day only. We protect landscaping where we can and clean the site before we leave.
Can you install EPDM over my old roof?
Sometimes, if there's a single sound layer. Most older roofs in town are better torn off, because wet boards hide underneath. We tell you which after we look.
What's the difference between EPDM and TPO?
EPDM is a rubber sheet with taped seams. TPO is a thermoplastic sheet with heat-welded seams, more common on commercial buildings. Both are single-ply roofs.
Do you repair leaking rubber roofs in Greenville?
Yes, through our flat roof repair service. If the membrane is cracked or shrinking across the whole roof, replacement is usually the better spend.
What drives the price of a new rubber roof?
Roof size, how many old layers come off, how much decking needs replacing and how many walls, vents and edges need flashing. We put all of it in the estimate.
