Reader's Choice Awards: Thank you for your votes – we WON!

We have won for the last 16yrs so please help us win this year.

We’ve been voted Reader’s Choice for the past 16 years! Support us again this year by clicking here.

Rubber Roofing in Englewood, OH

Call Us Today

Request a Service

Loading form…

Low-Slope Roofs Between the MetroPark and Main Street


Rubber roofing in Englewood tends to show up in two places: on the flat additions and porch roofs of houses in the Northmont area, and on the low-slope roofs of small businesses along Main Street. Both get the same treatment from us. A single sheet of EPDM, glued down, with seams and flashing done carefully.


Rich Roofing & Services has been roofing in Ohio since 1965. We install new rubber roofs and replace old flat roofs that have run out of life, and our office in Troy is a straight shot down the road from Englewood.


Leaking but otherwise solid? That's a repair, and it's covered on our page about flat roof leak repair in Englewood.


Contact us

Where EPDM Fits on Englewood Homes and Shops


EPDM is a synthetic rubber membrane that stays flexible through hard freezes and hot afternoons. It's made for roofs that are close to flat, where shingles would let water back up under the tabs.


Around town that means porch roofs, rear additions, attached garages with a shallow pitch and one-story commercial buildings near the SR-48 and I-70 interchange. If a roof has almost no fall, rubber is usually on the short list.


Houses near Englewood MetroPark and the Stillwater River sit under big trees. Leaves collect on flat roofs every fall, and when they clog a drain or scupper, water sits. The membrane can take it. The edges and drains are what need attention, so we plan those details around the trees.


Commercial owners who want a heat-welded membrane instead should read about TPO and PVC on our single ply roofing page for Englewood.

Picking Black or White, Glued or Ballasted


Every EPDM roofing job starts with a few choices. Here is how we explain them at the kitchen table:


Black membrane

The standard. It holds up well and absorbs sunlight, which helps snow and ice clear off sooner in winter.


White membrane

A reflective top surface that stays cooler in summer. It's worth a look when the flat roof is over a living space, and it usually costs more than black.


Fully adhered

The rubber is bonded with adhesive to a board laid over the deck. This is the method we use on most homes, because it resists wind and looks tidy from a second-floor window.


Mechanically attached

The sheet is fastened with plates and screws instead of glue. It shows up on some commercial roofs where the deck and the budget point that way.


Ballasted

The membrane is laid loose and weighed down with stone or pavers. It needs a structure built for the load, so it belongs on bigger commercial roofs, not on a porch.


Seams and flashing

No matter the method, the overlaps are primed and taped, and every wall, vent and edge gets its own flashing detail. That is the work that keeps a rubber roof dry for the long haul.

Why Englewood Owners Hand Their Flat Roofs to Rich Roofing

A few plain facts about who shows up for rubber roofing in Englewood:


Since 1965: We're a family company that has been roofing in Ohio for 60 years.


Licensed: We are a licensed roofing contractor and the crew is background-checked.


Free estimates: We come out, measure and explain the job at no charge.


Upfront pricing: The number you see covers the scope we described, and we talk through any change before it happens.

Recognized locally: Readers have voted us a Reader's Choice winner 16 times.


Latino-owned and Veteran-owned: That is who you are hiring.


Lower waste where possible: We choose eco-friendly materials when they fit the job.


Want to see the kind of work we do before you call? Photos of finished roofs are on our recent projects page.

What a Rubber Roof Replacement in Englewood Involves

Replacing an old flat roof with EPDM follows the same order every time, whether it's a porch or a storefront.

Measuring the Roof and the Walls Around It

We measure the roof, check how it drains and look at every wall, chimney and vent the membrane has to meet. A roof inspection in Englewood is part of the visit if the rest of the house needs a look too.

A Written Price Before Work Starts

You get a clear estimate. Price is driven by roof size, how many old layers come off, decking repairs and how much flashing is involved.

Tear-Off and Deck Repair

Old roofing comes off down to the deck. Soft or rotted boards get replaced so the new roof isn't sitting on a problem.

Adhering the EPDM Membrane and Taping Seams

Insulation or cover board goes down, then the rubber is rolled out, glued and pressed flat. Seams get primer and tape.

Edges, Drains and the Final Walk

New edge metal, pipe boots and wall flashing finish the roof. We clean up, walk it with you and answer questions before we leave. If the main roof is also tired, ask about a full roof replacement in Englewood.

Rubber Roofing for Englewood, Clayton, Union and Nearby Towns


Our crews cover all of Englewood plus Clayton, Union, Vandalia, Trotwood, Phillipsburg and West Milton. A homeowner searching rubber roofing near me from any of those towns is inside our usual route.


Business owners on Main Street looking for EPDM roofers near me can also ask about our commercial roofing work in Englewood, which covers larger flat roofs and other membranes. Homeowners can read more on residential roofing in Englewood.


When you're ready, request a free estimate Monday through Friday, 8 to 5, and we'll set a time to look at your roof. For general background on EPDM, see our rubber roofing system overview.

Rubber Roof Questions from Englewood


Contact us now
  • Is rubber roofing a good idea for a porch roof in Englewood?

    Yes, if the porch roof is nearly flat. EPDM handles standing water and cold far better than shingles on a low pitch. We check how the porch roof ties into the house wall before recommending it.

  • My flat roof is under big trees. Will rubber hold up?

    The membrane itself doesn't mind leaves. Trouble starts when leaves block a drain or gutter and water backs up. We plan the edge and drainage details around tree cover and suggest keeping them clear in the fall.

  • Can EPDM be installed in winter?

    It can in some conditions, but the adhesive and seam tape need dry surfaces and reasonable temperatures. We schedule around the weather so the bond is right. Spring through fall is the easiest window.

  • Do I need a full tear-off for flat roof replacement?

    Usually yes on older roofs, since old layers can trap moisture. If there's only one sound layer, a recover may be possible. We decide after seeing the roof.

  • What makes EPDM different from TPO?

    EPDM is rubber and its seams are taped. TPO is a thermoplastic sheet whose seams are welded with hot air. Both are single-ply membranes, and for most homes in Englewood we recommend EPDM.

  • Can you fix my leaking rubber roof instead of replacing it?

    Often, yes. Leak repairs are handled through our flat roof repair service. If the membrane is shrinking, cracked all over or the deck is soft, replacement makes more sense.

  • Do you do rubber roofing in Englewood for businesses?

    Yes. Small offices and shops with low-slope roofs are a good fit. For larger buildings we compare EPDM with other membranes and give you options.

  • How do I schedule an estimate?

    Call (937) 335-7663 or send a request through our website during weekday business hours. The visit and estimate are free.