Fastener, Seam and Rust Repairs for Dayton Metal Roofs
A steel roof can outlast almost anything else you could put on a building, but only if the small parts hold up. Rich Roofing & Services provides steel roof repair in Dayton for warehouses, workshops, commercial buildings, garages and homes, fixing the screws, seams, trim and rust spots that let water in long before the panels themselves wear out.
We are a family roofing company from Troy, up I-75, and we have worked on Ohio roofs since 1965. Our job here is to keep the roof you already have working, not to talk you into a new one. Shingles leaking instead? That is a job for our Dayton roof repair crew.
Where Dayton Steel Roofs Usually Start Leaking
The panels are tough. The weak points are everything that holds them together:
Fasteners and washers: exposed-fastener panels are held down by screws with rubber washers. Sun and temperature swings harden those washers until they crack, and expansion and contraction work the screws loose. Loose fasteners are one of the most common causes of a metal roof leak.
Seams and laps: where one panel overlaps the next, the sealant dries out and wind drives rain sideways into the gap.
Flashing and trim: ridge caps, rake trim, wall flashing and the boots around vent pipes all move with the roof. When they loosen or split, water follows.
Rust: scratches, cut edges and spots where leaves and dirt sit wet start to corrode. Left alone, a rusted metal roof panel eventually rusts through.
Metal Roof Fixes for Dayton Warehouses, Shops and Houses
Our Dayton steel roof repair covers a wide range of buildings, and each one comes with its own trouble spots.
Warehouses and commercial buildings: large roofs have hundreds of fasteners, skylight panels, rooftop units and long runs of trim. We work through them in sections so the business keeps running. Bigger projects are handled by our commercial roofing team in Dayton.
Homes and garages: standing seam and ribbed panels on houses need careful work around chimneys, dormers and gutters so the finish stays clean. Read more about our work on Dayton homes.
Hail and wind damage: spring storms can dent panels, crack old skylight panels or peel back trim along the eave. We replace the damaged pieces with matching profiles where they are available and photograph the damage for your records.
Restoration Coatings That Add Years to Dayton Metal
When a roof is structurally sound but showing its age, a metal roof coating can seal every seam and fastener head at once and slow rust across the whole surface.
Before any coating goes on, the roof has to be ready. We clean it, treat the rust, replace failed screws and seal the seams, because a coating will not hold over loose or crumbling metal.
Coatings are not right for every roof. If panels are rusted through in many places, coating them only hides the problem for a while.
When the panels themselves are finished, we will say so plainly and point you to our new metal roofing options in Dayton.
Some metal buildings also have a low, nearly flat section over an office or loading dock. Those need a different repair, which our flat roof repair in Dayton crew handles.
What Happens When We Come Out to a Dayton Metal Roof
Straightforward and on the record, from the first look to the last screw.
Up on the Panels for a Free Inspection
We walk the roof and check fasteners, seams, trim, flashing and rust, and we look inside for stains or daylight at the laps.
A Written Metal Roof Quote, Line by Line
You get a quote that lists each repair and why it is needed. Prices are upfront and honest, with no surprises later.
Screws, Sealants and Trim Chosen for Steel
We use fasteners sized up where old holes have worn oversized, sealants made for metal and trim that matches your panel profile.
Tightening, Sealing and Swapping Panels
Our crew replaces worn screws, reseals laps, refastens or replaces trim, treats rust and swaps out panels that cannot be saved.
One Last Walk Across the Roof with You
We show you what was done and what to keep an eye on. A yearly roof inspection helps you catch loose screws before they leak.
Steel Roof Service Around Riverside, Kettering and Vandalia
We repair metal roofs all over Dayton, from Old North Dayton and the shops off US-35 to the garages behind houses in Belmont and Walnut Hills, plus Kettering, Oakwood, Riverside, Trotwood, Huber Heights and Vandalia. If you searched steel roof repair near me or metal roof repair near me from any of those places, we are close. We are licensed and certified, family-run, and Latino-owned and Veteran-owned.
Get in touch or call (937) 335-7663, Monday through Friday from 8 to 5. You can also learn more about our family company or read up on steel roofs before we visit.
How do I know my steel roof needs repair?
Look for water stains below the roof, daylight at the panel laps, rust spots, screws that have backed out or lifted trim along the edges. Any of these means water is getting in or soon will.
Why do the screws on my metal roof keep backing out?
Steel expands in summer heat and shrinks in winter cold. Over years that movement works screws loose and cracks their rubber washers. We replace them with new fasteners, sized up where the old holes have worn.
Can you repair rust on a Dayton metal roof?
Yes, as long as the panel is not rusted through. We clean and treat the rust and seal the area. Panels with holes are patched or replaced, depending on how widespread the damage is.
Is a restoration coating worth it?
On a sound roof with surface rust and aging seams, a coating can add years. It only works after fasteners, seams and rust are repaired first, so we always fix those before coating.
What does steel roof repair in Dayton cost?
It depends on the size of the roof, how many fasteners and seams need work and whether panels need replacing. The inspection is free and you get a written price before work starts.
Do you repair hail damage on metal roofs?
Yes. Dents alone do not always leak, but cracked seams, punctured panels and loose trim do. We repair what lets water in and document the damage for your records.
Do you fix metal roofs on warehouses and commercial buildings?
Yes. We repair metal roofs on warehouses, shops and commercial buildings in Dayton and plan the work so your business can keep running.
When is it time to replace instead of repair?
When rust has eaten through many panels or the roof leaks in more places than it is worth patching. In that case we will tell you honestly and explain your options for a new metal roof.
